User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 254 System Manual
3.3.11.14.3 Enabling/Disabling VLAN Service Interface for an IP Service Group
This command is applicable only for an IP service group associated with a VLAN
service interface.
Run the following commands to enable/disable the creation of a data-path for a
VLAN Service:
To enable: npu(config-srvcgrp)# set vlan-enable
To disable: npu(config-srvcgrp)# no vlan-enable
{ms-loop
{enable|
disable}}
Denotes whether MS
loopback (direct
communication between two
MSs belonging to the same
service group) is enabled or
disabled for the service
interface
Optional Disable
 Enable
 Disable
[acctInterim
Tmr
<integer(0|5
-1600)>]
Applicable only if acct (see
above) mode is set to either
time or volumeTime. The
default interval in minutes for
Accounting Interim reports to
be used if
Acct-Interim-Interval is not
received from the AAA
server.
Value “0” means interim
reports are deactivated
unless Acct-Interim-Interval is
sent by the AAA server in
Access Accept messages.
Optional 5
 0
 5-1600
Command
Modes
IP Service group configuration mode
IMPORTANT
The default is disabled
Command
Syntax
npu(config-srvcgrp)# set vlan-enable
npu(config-srvcgrp)#
no vlan-enable