User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 119 System Manual

 Internal-management

 External-management

 Bearer

1 Enable the interface configuration mode (refer Section 3.3.2.3.1).

2 You can now:

» Shut down/Enable the Interface (refer to Section 3.3.2.3.2).

» Assign an IP address to an interface (refer to Section 3.3.2.3.3).

» Remove an IP address associated with an interface (refer to

Section 3.3.2.3.4).

» Modify the VLAN ID (refer to Section 3.3.2.3.5).

3 Modify the MTU (refer to Section 3.3.2.3.6).

4 Terminate the interface configuration mode (refer to Section 3.3.2.3.7).

You can, at any time, display configuration information for an IP interface (refer to

Section 3.3.2.3.8).

3.3.2.3.1 Enabling the Interface Configuration Mode

To configure an IP interface, run the following command to enable the interface

configuration mode:

npu(config)# interface {<interface-type> <interface-id>

all-au}

The following table lists the IP interfaces that each parameter represents:

IMPORTANT

You cannot modify the IP address and VLAN identifier for the internal-management interface.

To configure an IP interface:

NOTE

There is no need to shut down the interface for configuring its parameters.