User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 120 System Manual

After enabling the interface configuration mode for this interface, you can:

 Shut down/Enable the Interface (refer to Section 3.3.2.3.2)

 Assign an IP address to an interface (refer Section 3.3.2.3.3).

 Remove an IP address associated with an interface (refer Section 3.3.2.3.4).

 Modify the VLAN ID (refer Section 3.3.2.3.5).

 Modify the MTU (refer to Section 3.3.2.3.6).

Table 3-13: Parameters for Configuring the Interface Configuration Mode (IP Interfaces

IP Interface Parameter Example

Internal-management internal-mgmt npu(config)# interface internal-mgmt

External-management external-mgmt npu(config)# interface external-mgmt

Bearer bearer npu(config)# interface bearer

Local-management local-mgmt npu(config)# interface local-mgmt

IMPORTANT

To enable the interface configuration mode for IP interfaces, specify values for the for

internal-mgmt, external-mgmt, bearer, local-mgmt only. The interface-type and

interface-id parameters are used for enabling the interface configuration mode for physical

interfaces; the npu-host and all-au parameters are used for enabling the interface configuration

mode for virtual interfaces. For more information about configuring physical interfaces, refer

Section 3.3.2.1; refer Section 3.3.2.4 for configuring virtual interfaces.

Command

Syntax

npu(config)# interface {<interface-type> <interface-id>

all-au}

Privilege

Level