User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 143 System Manual
3.3.5.4.7 Restoring the Factory Default Configuration With Connectivity
You can, at any time, run the following command to restore factory default
configuration without changing any of the parameters required for maintaining
management connectivity to the unit:
npu# restore-factory-default-with-connectivity
The parameters that are maintained without any change include:
 Physical interfaces (MGMT, CSCD, DATA) configurations
 IP interfaces (local-management, external-management, bearer) configurations
 IP route configurations
 SNMP Managers configurations
 Trap Managers configurations
 AU software mapping
 Site ID
3.3.5.4.8 Displaying Failures in Configuration Restore Operations
When some configurations cannot be applied during NPU configuration restore
process, the NPU will not reset. Instead, the NPU will report the “Configurations
IMPORTANT
After executing this command, reset the system to apply the configuration change. For more
information about resetting the system, refer to
Section 3.2.2.1.
Command
Syntax
npu# restore-factory-default-with-connectivity
Privilege
Level
10
Command
Modes
Global command mode