User's Manual

60 4Motion System Manual
Chapter 2 - Installation
2.1.5.2 Connecting the Antenna Cable
1 Connect one end of the coaxial RF cable to the RF (ANT) connector located on
the bottom panel of the unit.
2 Connect the other end of the RF cable to the antenna.
3 The RF connectors should be properly sealed to protect against rain and
moisture.
2.1.5.3 Connecting the IF Cable
1 Connect one end of the coaxial IF cable to the IF connector located on the
bottom panel of the unit.
2 Verify that the length of the IF cable is sufficient to reach the AU/Power
Feeder. See IF cable length limitation in Section 2.1.2.
3 The IF cable connector should be properly sealed to protect against rain and
moisture.
4 Route the cable to the location selected for the indoor equipment.
To connect the RF cable:
To connect the IF cable: