User Manual

Chapter 2 - Installation Installing the Outdoor GPS Receiver
4Motion 95 System Manual
2.5 Installing the Outdoor GPS Receiver
Perform the following steps to install the Outdoor GPS Receiver
1 Place the bracket on a flat surface and thread the supplied pipe through the
bracket hole and into the GPS antenna. Hand-tighten until snug. Do not
over-tighten or use a tool. Make sure that the connector (male) is on the open
side of the bracket.
2 Assemble the surge protection cable onto the bracket using the supplied
screws, washers, and spring washers (2x1032). Apply torque 2.1 [N*m] (19.2
[lbs*in]). Make sure that the female connector faces the antenna.
3 Use a 1032 screw, washer, and spring washer to connect the surge protector’s
grounding cable to the bracket. Apply torque 2.1 [N*m] (19.2 [lbs*in]).
4 Connect the surge protector cable (female connector) to the GPS antenna
connector (male). Use the groove on the cable connector (indicatd by an arrow)
as a guide. It aligns with the tenon in the connector on the GPS side. Turn the
locking ring on the cable connector clockwise to secure the connection. Do not
over-tighten.
5 Use the supplied clamps to assemble the GPS and bracket on a pole. Use the
M8 nuts, washers, and spring washers to lock the clamps to the bracket.
Apply torque 9 [N*m] (80 [lbs*in]).