User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 789 System Manual
4.10.2.2.2 Resetting Statistics for the MIP-FA Functionality
Run the following command to reset statistics for the MIP-FA functionality
npu# clear mip-fa statistics
After you run this command, the statistics counter is reset to 0.
4.10.2.3 Managing Statistics for the PMIP Client Functionality
This section describes the commands to be used for:
 “Displaying Statistics for the PMIP Client Functionality” on page 789
 “Resetting Statistics for the PMIP Client Functionality” on page 791
4.10.2.3.1 Displaying Statistics for the PMIP Client Functionality
You can display statistics counters that provide information about the requests
and responses, and the number of active and failed IP address allocations by the
PMIP client functionality. The following table lists the statistics counters for the
PMIP client functionality:
Command
Modes
Global command mode
NOTE
The privilege level of this command is 15.
IMPORTANT
The PMIP client functionality is not supported in the current release.
Table 4-33: Statistics Counters for the PMIP Client Functionality
Statistics Counter Indicates the number of...
mipNumPmipMS MSs for which the NPU is serving as
the PMIP client.
mipRRPRx MIP registration responses received by
the PMIP client (NPU).
mipRRQTx MIP registration requests transmitted by
the PMIP client (NPU). This does not
include retransmissions.