User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 793 System Manual
Run the following command to display statistics for the Authenticator
functionality:
npu# show authenticator statistics
After you run this command, the statistics for the Authenticator functionality are
displayed.
eapReauthAttempts Reauthentication attempts processed
by the Authenticator functionality
(NPU).
eapInvalidNai Invalid NAIs received by the
Authenticator functionality (NPU).
eapInvalidNaiLen Times an NAI with an invalid length is
received by the Authenticator
functionality (NPU) in the EAP
response ID message.
eapInvalidNaiRealm Times an NAI with an invalid realm is
received by the Authenticator
functionality (NPU) in the EAP
response ID message.
eapInvalidNaiPseudoId Times an NAI with an invalid psuedo ID
is received by the Authenticator
functionality in the EAP response ID
message.
eapNaiMismatchAuthMode Times an NAI with an invalid
authentication mode is received by the
Authenticator functionality in an EAP
response ID message.
authUnauthMS Unauthnticated MSs.
arpEapTransferTx EAP transfers transmitted by the
Authenticator functionality (NPU).
arpEapTransferRx EAP transfers received by the
Authenticator functionality (NPU).
arpEapTransferDrop EAP transfers dropped by the
Authenticator functionality (NPU).
arpEapStartRx EAP start messages received by the
Authenticator functionality (NPU).
arpEapStartDrop EAP start messages dropped by the
Authenticator functionality (NPU).
Table 4-34: Statistics Counters for the Authenticator Functionality
Statistics Counter Indicates the number of...