User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 808 System Manual
4.10.2.8.2 Resetting Statistics for RADIUS
Run the following command to reset RADIUS statistics:
npu# clear radius statistics
After you run this command, the statistics counter is reset to 0.
4.10.2.9 Managing Statistics for the DHCP Server
This section describes the commands to be used for:
 “Displaying Statistics for the DHCP Server” on page 809
 “Resetting DHCP Server Statistics” on page 810
Display
Format
Radius Statistics :
radAccessReqTx = <value>
radAccessReqRtx = <value>
radAccessChallengeRx = <value>
radAccessAcceptRx = <value>
radAccessRejectRx = <value>
radAccessChallengeDrop = <value>
radAccessAcceptDrop = <value>
radAccessRejectDrop = <value>
radTimerAccessReqExp = <value>
radCounterAccessReqExp = <value>
radInvalidEvent = <value>
radMsProfileChange = <value>
radEapMismatch = <value>
Command
Modes
Global command mode
NOTE
The privilege level of this command is 10.