User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 694 System Manual
4.8.21.3 Displaying Configuration Information for Bearer Interface
Parameters
To display configuration information of Bearer Interface parameters, run the
following command:
npu# show bearer bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Bearer Interface parameters of BS 66053, run the
following command:
npu# show bearer bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show bearer bs
NOTE
Refer to Section 4.8.21.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no bearer [mtu-size ] [linkusage-hardthrshld ]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show bearer bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1