User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 814 System Manual
4.10.2.11.2 Resetting Statistics for the DHCP Relay
Run the following command to reset statistics for the DHCP relay:
npu# clear dhcp-relay statistics
After you run this command, the statistics counter is reset to 0.
4.10.2.12 Managing Statistics for the SFA Functionality
You can display statistics counters for the DHCP relay. This section describes the
commands to be used for:
 “Displaying Statistics for the SFA Functionality” on page 814
 “Resetting Statistics for the SFA Functionality” on page 815
4.10.2.12.1 Displaying Statistics for the SFA Functionality
The following table lists the statistics counters for the SFA functionality:
Run the following command to display statistics for the SFA functionality.
npu# show sfa statistics
After you run this command, the statistics for the SFA functionality are displayed.
Command
Modes
Global command mode
NOTE
The privilege level of this command is 10.
Table 4-42: Statistics Counters for the SFA Functionality
Statistics Counter Indicates the number of Times...
sfaQosMappingFail QoS mapping has failed.
sfaSfDescMissing Service flow description is missing.
sfaDfltLpApplied Default local profile is applied.
sfaRejMsMissingProf MSs are rejected rejected because of a
missing service profile.
sfaLocalServProfApplied Local service profile is applied.