User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 815 System Manual
4.10.2.12.2 Resetting Statistics for the SFA Functionality
Run the following command to reset statistics for the SFA functionality:
npu# clear sfa statistics
After you run this command, the statistics counter is reset to 0.
4.10.3 Displaying Statistics for Physical and IP
Interfaces
The following table lists the statistics counters for the physical interfaces:
Command
Syntax
npu# show sfa statistics
Privilege
Level
1
Display
Format
SFA Statistics :
sfaQosMappingFail = <value>
sfaSfDescMissing = <value>
sfaDfltLpApplied = <value>
sfaRejMsMissingProf = <value>
sfaLocalServProfApplied = <value>
Command
Modes
Global command mode
NOTE
The privilege level of this command is 10.
Table 4-43: Statistics Counters for the Physical Interfaces
Statistics Counter Indicates the number of...
rxUnicast Packets Unicast packets received by the AU.
rxMulticast Packets Multicast packets received by the AU.
rxBroadcast Packets Broadcast packets received by the AU.
rxDiscarded Packets Discarded packets received by the AU.