User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 817 System Manual
Table 4-45: Parameters for Displaying Statistics for All Physical, IP, and Virtual Interfaces
Interface Parameters Example
Physical
Interfaces
Fast Ethernet:
<interface-type
>
<interface-id>
npu# show interfaces fastethernet 0/1 counters
npu# show interfaces fastethernet 0/2 counters
npu# show interfaces fastethernet 0/3 counters
npu# show interfaces fastethernet 0/4 counters
npu# show interfaces fastethernet 0/5 counters
npu# show interfaces fastethernet 0/6 counters
npu# show interfaces fastethernet 0/7 counters
npu# show interfaces fastethernet 0/8 counters
Gigabit Ethernet
<interface-type
>
<interface-id>
npu# show interfaces gigabitethernet 0/9 counters
npu# show interfaces gigabitethernet 0/10 counters
IP
Interfaces
internal-mgmt npu# show interfaces internal-mgmt counters
external-mgmt npu# show interfaces external-mgmt counters
bearer npu# show interfaces bearer counters
local-mgmt npu# show interfaces local-mgmt counters
IMPORTANT
An error may occur if:
 The interface type or interface ID you have specified is incorrect. Refer the syntax description for
more information about the appropriate values for configuring these parameters.
 The IP interface does not exist for the configured connectivity and boot mode.
Command
Syntax
npu# show interfaces [{[<interface-type> <interface-id>] | internal-mgmt
| external-mgmt | bearer | local-mgmt}] counters
Privilege
Level
1