User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 695 System Manual
4.8.22 Managing Authentication Relay Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Authentication parameters (refer to
Section 4.8.22.1).
 Restore the default values of some or all of the Authentication non-mandatory
parameters (refer to Section 4.8.22.2).
You can display configuration information for the Authentication parameters of a
selected or all existing BSs (refer to Section 4.8.22.3).
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display Bearer Interface
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display Bearer Interface
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
IPAddress :<value>
IPsubnetMask :<value>
DefaultGateway :<value>
MTUSize :<value>
LinkUsageHardThreshold(%) :<value>
Command
Modes
Global command mode