User Manual

Chapter 4 - Operation and Administration Using the CLI Troubleshooting
4Motion 830 System Manual
 Source interfaces: Refers to the FastEthernet or GigabitEthernet interface for
which incoming, outgoing or both types of traffic is to be monitored. You can
configure port monitoring for one or more source interfaces.
 Destination interface: Refers to the interface where the packets are sent for
analysis.
 Direction of the traffic that is to be monitored
The following table lists the interfaces that can be mirrored, and the port numbers
mapping to these interfaces:
This section describes the commands to be used for:
 “Enabling the Port Monitoring Session” on page 830
 “Disabling a Port Monitoring Session” on page 833
 “Displaying Configuration Information for Source and Destination Interfaces”
on page 834
4.11.2.1 Enabling the Port Monitoring Session
The port monitoring session refers to the association of a destination interface
with one or more source interfaces. You can monitor incoming, outgoing or both
types of traffic that is mirrored from the source interface to the destination
interface.
Table 4-47: Interface to Ethernet Port Mapping
Ethernet Port Interface Type Interface ID
AU1 Fast Ethernet 0/1
AU2 Fast Ethernet 0/2
AU3 Fast Ethernet 0/3
AU4 Fast Ethernet 0/4
AU5 Fast Ethernet 0/5
AU6 Fast Ethernet 0/6
AU7 Fast Ethernet 0/7
MGMT Fast Ethernet 0/8
CASCD Gigabit Ethernet 0/9