User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 696 System Manual
4.8.22.1 Configuring Authentication Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# auth-general [dflt-auth-ip-address <ip address>]
[suspendedeapprocthrshld <(0 to 10000 StepSize 1)>] [activemsthrshld <(0 to
1024 StepSize 1)>] [maxeaproundsthrshld <(0 to 100 StepSize 1)>]
[nonauth-macctrlratethrshld <(0 to 120000 StepSize 1)>]
[nonauth-pduratethrshld <(0 to 120000 StepSize 1)>]
To configure the Authentication parameters:
Command
Syntax
npu(config-bs-66053)# auth-general [dflt-auth-ip-address <ip address>
] [suspendedeapprocthrshld <(0 to 10000 StepSize 1)> ]
[activemsthrshld <(0 to 1024 StepSize 1)> ] [maxeaproundsthrshld
<(0 to 100 StepSize 1)> ] [nonauth-macctrlratethrshld <(0 to
120000 StepSize 1)> ] [nonauth-pduratethrshld <(0 to 120000
StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[dflt-auth-ip-address
<ip address> ]
Identifier (IP address) of
“default” authenticator
ASN GW.
Mandatory
when
creating a
new BS.
N/A IPv4 address
[suspendedeapprocth
rshld <(0 to 10000
StepSize 1)> ]
Suspended EAP
authentification process
threshold. It is used to set
an alarm.
Optional 0 0 to 10000