User Manual

4Motion Configuration Using AlvariSTAR Scope
1 Scope
The purpose of this document is to guide you through the elementary
configuration steps that must be carried out to manage a 4Motion release
2.5 site via the AlvariSTAR EMS system and to establish a first link with the
BTS.
Please note: this document describes a specific configuration with specific
IP addresses and specific values. The purpose of this example is to
demonstrate site configuration with air link and CPE management support.
The CPE Management configuration refers to Star-ACS supporting CPEs
with TR69 only. The CPE described in this example is BreezeMAX PRO CPE
and BreezeMAX Si CPE with the Rosedale 2 chipset supporting TR69.
Please use the following configuration description as a reference only and
change all parameters values, IP addresses, operator and BS IDs according
to the required parameters in the field.
Configuration description:
The configuration described in this document is as follows:
 One site with one AU, one ODU, one Antenna, one BS, one Site Sector
 VLAN Service Type is used in this example. For a description of IP-in-IP
Service Type, see Annex A.
 Radio configuration: band 2.5 GHz with 10 MHz bandwidth and central
frequency 2600.
Software supported
This document supports 4Motion Release 2.5 with the following internal
versions:
 NPU: 2_5_12_2
 AU: 2_5_0_32
 AlvariSTAR infrastructure 4.0.0.87 with 4Motion Device Driver 2.5.1.57.
2 Pre-Configuration Requirements
The following must be configured before using AlvariSTAR.
1. Access the CLI from local terminal
To access the CLI via the MON connector, use the following parameter
values:
Table 1: CLI Parameters
4Motion - DN1031 1