User Manual

4Motion Configuration Using AlvariSTAR 4Motion Configuration
(10.0.22.29 is an example for the IP address of the default route.)
npu# c t
npu(config)# ip route 0.0.0.0 0.0.0.0 10.0.22.29 (default gateway ip address
next hop)
npu(config)# exit
npu# wr
Configurations saved successfully
3.1.6 Creating the AU-to-Image Mapping
Map AU software version to a specific AU slot. You can also use this image
to create the default AU-to-image mapping.
npu# c t
npu(config)# map au default AU_2_0_9_3 (AU version name)
npu(config)# exit
npu# wr
Configurations saved successfully
IMPORTANT
If you are inserting/re-inserting the AU card, run this command before inserting and powering
up the AU card.
3.2 Configuration Via AlvariSTAR
From this part on, use AlvariSTAR to configure the system.
In each BS Managed Object (MO) window, it is mandatory to Apply the
screen configuration even if you use the default parameters.
3.2.1 L1\L2 Connectivity
Select Connectivity > L1/L2 Connectivity > Site Connectivity from the
navigation tree.
If the system uses in-band mode, Click Apply to accept the default values.
When working in in-band mode, the administrative status of the backhaul
port must always be up, otherwise you will lose connection with BTS.
4Motion - DN1031 5