User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 683 System Manual
4.8.20 Managing Rate Adaptation Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Rate Adaptation parameters (refer to
Section 4.8.20.1).
 Restore the default values of some or all of the Rate Adaptation parameters
(refer to Section 4.8.20.2).
You can display configuration information for the Rate Adaptation parameters of a
selected or all existing BSs (refer to Section 4.8.20.3).
4.8.20.1 Configuring Rate Adaptation Parameters
From the BS configuration mode, run the following command:
Command
Syntax
npu# show airframe-all bs [<(1 to 16777215 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display all Airframe
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display all Airframe
parameters of all BSs.
Optional N/A 1-16777215
Command
Modes
Global command mode
To configure the Rate Adaptation parameters: