User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 701 System Manual
enable-teksharing
<hex-string>
2 hexadecimal digits that
can be represented as 8
bits iIdentifying re-entry
process management
messages that may be
omitted during the current
HO attempt. The omission
is due to the availability of
MS service and
operational context
information and the MS
service and operational
status post-HO
completion.
Currently only bit 2 can be
modified: A value of “ff”
(bit 2 = 1) means that
PKM TEK creation phase
is omitted (TEK Sharing is
enabled). A value of “cf
(bit 2 = 0) means that the
message is not omitted
(TEK Sharing is disabled).
Optional ff
 ff
 fb
rtxtimer <(0 to 255
StepSize 1)>
MS Handover
Retransmission Timer:
After an MS transmits
MOB_MSHO-REQ to
initiate a handover
process it shall start MS
Handover Retransmission
Timer and shall not
transmit another
MOB_MSHO-REQ until
the expiration of the MS
Handover Retransmission
Timer.
Optional 10 0 - 255
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, at least one of the Handover Control parameters must be configured
explicitly (even if configured to the default value).