User Manual

4Motion Configuration Using AlvariSTAR 4Motion Configuration
Figure 5: New ODU
A new ODU is added to the navigation tree according to the ODU
number (e.g. ODU 2). This new screen allows ODU configuration.
6. On the ODU configuration screen, click Apply to accept the default
values.
IMPORTANT
You must click Apply on the ODU configuration screen to complete the ODU creation even if
no change was made to the screen.
To verify that the ODU was added successfully, verify that the HPA Card value is Not Installed
(see Figure 6).
Figure 6: ODU
3.2.7 GPS
1. Select Equipment > External > GPS from the navigation tree.
2. Configure the GPS type according the setup. The available option is
Trimble. If no GPS is used, select None.
3. Click Apply to accept the changes.
4Motion - DN1031 11