User Manual

4Motion Configuration Using AlvariSTAR 4Motion Configuration
IMPORTANT
Any change in this screen requires NPU reset. You can restart the NPU after the entire
configuration is complete.
3.2.8 Antenna
This section describes the parameters needed in order to configure the
antennas settings.
NOTE
The default values presented in this document are used only to provide the minimal
requirements for establishing a connection. The numbers serve only as an example and
should be adjusted in order to receive best radio performance.
1. Select Equipment > External > Antenna from the navigation tree.
2. Click ADD to create a new antenna settings.
3. Configure the required parameters described in Figure 7.
4. Repeat the antenna configuration for each of the connected antennas.
5. Click on the Apply button to accept the changes.
IMPORTANT
Port Number and Heading are mandatory parameters.
Figure 7: Antenna
4Motion - DN1031 12