User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 703 System Manual
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Handover Control parameters of BS 66053, run the
following command:
npu# show hoctrl bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show hoctrl bs
Command
Syntax
npu# show hoctrl bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display Handover Control
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display Handover Control
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
EnableTEKSharing :<value>
MSHandoverRetransmissionTimer(frames) :<value>
SchedulingServiceSupport :<value>
Command
Modes
Global command mode