User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 709 System Manual
4.8.24.4 Terminating the Bearer Traffic QoS Marking Rule
Configuration Mode
Run the following command to terminate the Bearer Traffic QoS Marking Rule
configuration mode:
npu(config-bs-66053-bearertrafficqos-1)# exit
4.8.24.5 Deleting a Bearer Traffic QoS Marking Rule
Run the following command from the BS configuration mode to delete a Bearer
Traffic QoS Marking Rule:
npu(config-bs 66053)# no
bearertrafficqos <(1 to 16383 StepSize 1)>
Command
Syntax
npu(config-bs-66053-bearertrafficqos-1)# no mrkngrule [rule-status ]
[rule-name ] [srvcflow-datadeliverytype [srvcflow-trafficpriority
] [outerdscp ] [bp8021p ]
Privilege
Level
10
Command
Modes
bs bearer traffic qos marking rule configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the BS Bearer Traffic QoS Marking
Rule configuration mode:
npu(config-bs-66053-bearertrafficqos-1)# apply
Command
Syntax
npu(config-bs-66053-bearertrafficqos-1)# exit
Privilege
Level
10
Command
Modes
bs bearer traffic qos marking rule configuration mode