User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 715 System Manual
4.8.25.3 Restoring Default Values for Control Traffic QoS Marking
Rules Configuration Parameters
After enabling the Control Traffic QoS Marking Rules configuration mode you can
restore the default values for parameters in the following parameters tables:
 Internal Management (refer to Section 4.8.25.3.1)
 Intra ASN (refer to Section 4.8.25.3.2)
4.8.25.3.1 Restoring the Default Values of Internal Management Traffic QoS
Marking Rules Parameters
To restore one or all of the Internal Management Traffic QoS Marking Rules
parameters to their default values, run the following command:
npu(config-bs-66053-ctrltrafficqos)# no intmngmnt [dscp] [inter8021p]
You can restore only one parameter to its default values by specifying only that
parameter. For example, to restore only dscp to the default value, run the
following command:
npu(config-bs-66053-ctrltrafficqos)# no intmngmnt dscp
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all Internal Management Traffic QoS Marking Rules parameters to their
default value, run the following command:
npu(config-bs-66053-ctrltrafficqos)# no intmngmnt
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
dscp <(0 to 63
StepSize 1)>
DSCP priority value to be
used for marking of
intra-ASN (R8/R6) traffic
Optional 0 0 - 63
intra8021p <(0 to
7 StepSize 1)>
802.1p priority value to be
used for marking of
intra-ASN (R8/R6) traffic
Optional 0 0 - 7
Command
Modes
bs control traffic qos marking rules (ctrltrafficqos) configuration mode