User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 716 System Manual
4.8.25.3.2 Restoring the Default Values of Intra ASN Traffic QoS Marking Rules
Parameters
To restore one or all of the Intra ASN Traffic QoS Marking Rules parameters to
their default values, run the following command:
npu(config-bs-66053-ctrltrafficqos)# no intraasn [dscp] [intra8021p]
You can restore only one parameter to its default values by specifying only that
parameter. For example, to restore only dscp to the default value, run the
following command:
npu(config-bs-66053-ctrltrafficqos)# no intraasn dscp
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all Intra ASN Traffic QoS Marking Rules parameters to their default
value, run the following command:
npu(config-bs-66053-ctrltrafficqos)# no intraasn
NOTE
Refer to Section 4.8.25.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-ctrltrafficqos)# no intmngmnt [dscp ]
[inter8021p ]
Privilege
Level
10
Command
Modes
bs control traffic qos marking rules (ctrltrafficqos) configuration mode
NOTE
Refer to Section 4.8.25.2.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-ctrltrafficqos)# no intraasn [dscp ]
[intra8021p ]
Privilege
Level
10