User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 717 System Manual
4.8.25.4 Terminating the Control Traffic QoS Marking Rules
Configuration Mode
Run the following command to terminate the Control Traffic QoS Marking Rules
configuration mode:
npu(config-bs-66053-ctrltrafficqos)# exit
4.8.25.5 Displaying Configuration Information for Control Traffic QoS
Marking Rules Parameters
You can display the current configuration information for the following
parameters tables:
 Internal Management (refer to Section 4.8.25.5.1)
 Intra ASN (refer to Section 4.8.25.5.2)
 All (refer to Section 4.8.25.5.3)
4.8.25.5.1 Displaying Configuration Information for Internal Management Traffic
QoS Marking Rules Parameters
To display configuration for the Internal Management Traffic QoS Marking Rules
parameters, run the following command:
npu# show ctrltrafficqos-intmngmnt bs [<(1 to 16777215 StepSize 1)
Command
Modes
bs control traffic qos marking rules (ctrltrafficqos) configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the Control Traffic QoS Marking
Rules configuration mode: npu(config-bs-66053-ctrltrafficqos)# apply
Command
Syntax
npu(config-bs-66053-ctrltrafficqos)# exit
Privilege
Level
10
Command
Modes
bs control traffic qos marking rules (ctrltrafficqos) configuration mode