User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 725 System Manual
You can display configuration information for the ID-IP Mapping of a selected or
all existing BSs (refer to Section 4.8.27.3).
4.8.27.1 Configuring ID-IP Mapping Entries
From the BS configuration mode, run the following command:
npu(config-bs-66053)# idip <(1 to 16777215 StepSize 1)> [nw-node-ip <ip
address>]
4.8.27.2 Deleting an ID-IP Mapping Entry
Run the following command from the BS configuration mode to delete an ID-IP
Mapping entry:
npu(config-bs 66053)# no idip <(1 to 16777215 StepSize 1)>
To configure ID-IP Mapping entries:
Command
Syntax
npu(config-bs-66053)# idip <(1 to 16777215 StepSize 1)> [nw-node-ip
<ip address> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The Next Hop (Network
Node) BS ID
Mandatory N/A 1 - 16777215
nw-node-ip <ip
address>
The Next Hop (Network
Node) BS IP Address
Mandatory N/A IP address
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, at least one ID-IP Mapping entry must be configured.