User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 726 System Manual
4.8.27.3 Displaying Configuration Information for ID-IP Mapping
Entries
To display configuration information of ID-IP Mapping entries, run the following
command:
npu# show idip bs [<(1 to 16777215 StepSize 1)> nw-node-id <(1 to 16777215
StepSize 1)>]
Specify the BS ID and Next Hop (Network Node) BS ID (nw-node-id) if you want to
display information for a particular ID-IP Mapping entry. For example, to display
the ID-IP Mapping of BS 66053 and Network Node 66055, run the following
command:
npu# show idip bs 66053 nw-node-id 66055
Do not specify these parameters if you want to view information of ID-IP Mapping
entries in all existing BSs. To display information for all BSs, run the following
command:
npu# show idip bs
Command
Syntax
npu(config-bs 66053)# no idip <(1 to 16777215 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The Next Hop (Network
Node) BS ID
Mandatory N/A 1 - 16777215
Command
Modes
bs configuration mode
Command
Syntax
npu# show idip bs [<(1 to 16777215 StepSize 1)> nw-node-id <(1 to 16777215 StepSize 1)> ]