User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 728 System Manual
4.8.28 Managing Ranging Parameters
1 Enable the Ranging configuration mode (refer to Section 4.8.28.1)
2 You can now execute any of the following tasks:
» Configure one or more of the Ranging parameters tables (refer to
Section 4.8.28.2)
» Restore the default values of parameters in one or more of the Ranging
parameters tables (refer to Section 4.8.28.3)
» Terminate the Ranging configuration mode (refer to Section 4.8.28.4)
In addition, you can, at any time, display configuration information for each of the
parameters tables (refer to Section 4.8.28.5).
4.8.28.1 Enabling the Ranging Configuration Mode
To configure the Ranging parameters, first enable the Ranging configuration
mode. Run the following command to enable the Ranging configuration mode.
Note that for properly completing the configuration the apply command must be
executed prior to exiting the Ranging configuration mode.
npu(config-bs-66053)# ranging
The Ranging configuration mode is enabled, after which you can execute any of
the following tasks:
 Configure one or more of the Ranging parameters tables (refer to
Section 4.8.28.2)
 Restore the default values of parameters in one or more of the parameters
tables (refer to Section 4.8.28.3)
After executing the above tasks, you can terminate the Ranging configuration
mode (refer to Section 4.8.28.4) and return to the BS configuration mode.
Note that for properly completing the Ranging configuration the apply command
must be executed prior to exiting the Ranging configuration mode.
To configure the Ranging parameters: