User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 729 System Manual
4.8.28.2 Configuring Ranging Parameters
After enabling the Ranging configuration mode you can configure the following
parameters tables:
 General (refer to Section 4.8.28.2.1)
 Bandwidth Request (refer to Section 4.8.28.2.2)
 Handover Ranging (refer to Section 4.8.28.2.3)
 Initial Ranging (refer to Section 4.8.28.2.4)
 Periodic Ranging (refer to Section 4.8.28.2.5)
 Timing Correction (refer to Section 4.8.28.2.6)
4.8.28.2.1 Configuring Ranging General Parameters
To configure the Ranging General parameters, run the following command:
npu(config-bs-66053-ranging)# general [start-of-rng-codes <(0 to 255 StepSize
1)>] [contbased-rsrvtimeout <(0 to 255 StepSize 1)>] [max-cellradius {one | two |
four | eight | fifteen | twentyThree | thirty}]
Command
Syntax
npu(config-bs-66053)# ranging
Privilege
Level
10
Command
Modes
bs configuration mode
IMPORTANT
After completing the Ranging configuration,do not forget to execute the apply command before
exiting the Ranging configuration mode:
npu(config-bs-66053-ranging)# apply
IMPORTANT
When creating a new BS, at least one of the Ranging General parameters must be configured
explicitly (even if configured to the default value).