User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 734 System Manual
4.8.28.2.5 Configuring Periodic Ranging Parameters
To configure the Periodic Ranging parameters, run the following command:
npu(config-bs-66053-ranging)# periodicrng [codes <(0 to 255 StepSize 1)>]
[init-backoff-window-size <(0 to 15 StepSize 1)>] [final-backoff-window-size <(0 to
15 StepSize 1)>]
codes <(0 to 255
StepSize 1)>
Number of Initial Ranging
CDMA Codes.
Note that the sum of initial
ranging codes, periodic ranging
codes, bandwidth request
codes, handover ranging codes
and start of ranging codes
should be equal to or less than
256.
Optional 14 0 - 255
init-backoff-window
-size <(0 to 15
StepSize 1)>
Initial backoff window size for
initial ranging contention ;
expressed as a power of 2.
Optional 0 0 - 15
final-backoff-windo
w-size <(0 to 15
StepSize 1)>
Final backoff window size for
initial ranging contention;
expressed as a power of 2.
Cannot higher than or equal to
initrng init-backoff-window-size.
Optional 4 0 - 15
Command
Modes
bs ranging configuration mode
IMPORTANT
When creating a new BS, at least one of the Periodic Ranging parameters must be configured
explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-ranging)# periodicrng [codes <(0 to 255 StepSize
1)> ] [init-backoff-window-size <(0 to 15 StepSize 1)> ]
[final-backoff-window-size <(0 to 15 StepSize 1)> ]
Privilege
Level
10