User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 737 System Manual
npu(config-bs-66053-ranging)# no general max-cellradius
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all Ranging General parameters to their default value, run the following
command:
npu(config-bs-66053-ranging)# no general
4.8.28.3.2 Restoring the Default Values of Ranging Bandwidth Request
Parameters
To restore one or all of the Ranging Bandwidth Request parameters to their
default values, run the following command:
npu(config-bs-66053-ranging)# no bwreq [codes] [init-backoff-window-size]
[final-backoff-window-size]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the codes parameter to the default
value, run the following command:
npu(config-bs-66053-ranging)# no bwreq codes
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all Ranging Bandwidth Request parameters to their default value, run
the following command:
npu(config-bs-66053-ranging)# no bwreq
NOTE
Refer to Section 4.8.28.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-ranging)# no general [start-of-rng-codes ]
[contbased-rsrvtimeout ] [max-cellradius ]
Privilege
Level
10
Command
Modes
bs ranging configuration mode