User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 742 System Manual
4.8.28.5 Displaying Configuration Information for Ranging
Parameters
You can display the current configuration information for the following
parameters tables:
 General (refer to Section 4.8.28.5.1)
 Bandwidth Request (refer to Section 4.8.28.5.2)
 Handover Ranging (refer to Section 4.8.28.5.3)
 Initial Ranging (refer to Section 4.8.28.5.4)
 Periodic Ranging (refer to Section 4.8.28.5.5)
 Timing Correction (refer to Section 4.8.28.5.6)
 All (refer to Section 4.8.28.5.7)
4.8.28.5.1 Displaying Configuration Information for Ranging General Parameters
To display configuration for the Ranging General parameters, run the following
command:
npu# show ranging-general bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Ranging General parameters of BS 66053, run the
following command:
npu# show ranging-general bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show ranging-general bs
Command
Syntax
npu# show ranging-general bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1