User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 750 System Manual
4.8.29 Managing Alarm Threshold Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Alarm Threshold parameters (refer to
Section 4.8.29.1).
 Restore the default values of some or all of the Alarm Threshold parameters
(refer to Section 4.8.29.2).
You can display configuration and status information for the Alarm Threshold
parameters of a selected or all existing BSs (refer to Section 4.8.29.3).
4.8.29.1 Configuring Alarm Threshold Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# alrm-thrshld [dl-droppedpackets <(1 to 1000 StepSize
1)>] [unalloc-slots <(1 to 100 StepSize 1)>] [dl-retransmissions <(-1 to -1 StepSize
1) | (1 to 10 StepSize 0.1)>] [ul-retransmissions <(-1 to -1 StepSize 1) | (1 to 10
StepSize 0.1)>] [dl-subburstdrop <(0 to 100 StepSize 0.01)>] [ul-subburstdrop <(0
to 100 StepSize 0.01)>] [ul-mednoise <(-130 to 0 StepSize 1)>] [ul-99prcntnoise
<(-130 to 0 StepSize 1)>]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display all Ranging
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display all Ranging
parameters of all BSs.
Optional N/A 1-16777215
Command
Modes
Global command mode
To configure the Alarm Threshold parameters: