User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 753 System Manual
To restore all Alarm Threshold parameters to their default value, run the following
command:
npu(config-bs-66053)# no alrm-thrshld
4.8.29.3 Displaying Configuration Information for Alarm Threshold
Parameters
To display configuration information of Alarm Threshold parameters, run the
following command:
npu# show alrm-thrshld bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Alarm Threshold parameters of BS 66053, run the
following command:
npu# show alrm-thrshld bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show alrm-thrshld bs
NOTE
Refer to Section 4.8.29.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no alrm-thrshld [dl-droppedpackets ]
[unalloc-slots ] [dl-retransmissions ] [ul-retransmissions ]
[dl-subburstdrop ] [ul-subburstdrop ] [ul-mednoise ]
[ul-99prcntnoise ]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show alrm-thrshld bs [<(1 to 16777215 StepSize 1)