User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 689 System Manual
4.8.20.2 Restoring the Default Values of Rate Adaptation Parametes
To restore the default values of some or all of the Rate Adaptation parameters, run
the following command:
npu(config-bs-66053)# no rateadapt-general [dl-basicrate] [ul-basicrate]
[mincinr-qpsk-1by2-rep6] [mincinr-qpsk-1by2-rep4] [mincinr-qpsk-1by2-rep2 >]
[mincinr-qpsk-1by2] [mincinr-qpsk-3by4] [mincinr-qam16-1by2]
[mincinr-qam16-3by4] [mincinr-qam64-1by2] [mincinr-qam64-2by3]
[mincinr-qam64-3by4] [mincinr-qam64-5by6]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the ul-basicrate parameter to the
default value, run the following command:
npu(config-bs-66053)# no rateadapt-general ul-basicrate
mincinr-qam64-3by4
<(-20 to 30 StepSize
0.1)>
The minimal CINR
in dB Required to
allow 64QAM 3/4
Uplink
transmissions.
Must be in the
range from
mincinr-qam64-2by
3 to
mincinr-qam64-5by
6
Optional -20 -20 to 30 in steps of 0.1
mincinr-qam64-5by6
<(-20 to 30 StepSize
0.1)>
The minimal CINR
in dB Required to
allow 64QAM 5/6
Uplink
transmissions.
Cannot be lower
than
mincinr-qam64-3by
4
Optional -20 -20 to 30 in steps of 0.1
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, at least one of the Rate Adaptation parameters must be configured
explicitly (even if configured to the default value).