User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Sectors
4Motion 764 System Manual
4.9 Managing Sectors
Up to 6 Sector objects can be created and configured. The Sector’s configuration
includes the association of all the objects that form a sector, including BS,
AU/AU-Port, ODU/ODU-Port and Antenna/Antenna Port.
This section include:
 “Configuring Sector Parameters”, Section 4.9.1
 “Configuring Sector Association Entries”, Section 4.9.2
4.9.1 Configuring Sector Parameters
1 Enable the Sector Parameters configuration mode for the selected Sector (refer
to Section 4.9.1.1)
2 You can now execute any of the following tasks:
» Configure one or more of the parameters tables of the Sector (refer to
Section 4.9.1.2)
» Restore the default values of parameters in one or more of the parameters
tables of the Sector (refer to Section 4.9.1.3)
3 Terminate the Sector Parameters configuration mode (refer to Section 4.9.1.4)
In addition, you can, at any time, display configuration information for each of the
parameters tables of the Sector (refer to Section 4.9.1.6) or delete an existing
Sector object (refer to Section 4.9.1.5).
4.9.1.1 Enabling the Sector Parameters Configuration
Mode\Creating a Sector Object
To configure the parameters of a Sector, first enable the Sector Parameters
configuration mode for the specific Sector. Run the following command to enable
the Sector Parameters configuration mode for an existing Sector object:
npu (config)# sector-params <(1 to 6 StepSize 1)>
To configure Sector Parameters: