User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 205 System Manual
4.3.7.2.2 Configuring a QoS Classification Rule
You can configure the QoS classification rules for the ACL with respect the
following parameters:
 Source IP address for the host-originating application traffic
 Application protocol (TCP or UDP)
 L4 source port of the application traffic
 QoS class-map identifier
By default, there are 8 pre-configured QoS classification rules associated with the
8 pre-configured QoS class-maps:
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
extended
<access-list-n
umber
(100-199)>
Indicates the identifier of the
extended ACL for which the
ACL configuration mode is to
be enabled. You must specify
199 to enable configuration of
QoS classification rules.
Mandatory N/A 199
[name
<string>]
Indicates the name of the
ACL for which the ACL
configuration mode is to be
enabled.
Note: If you do not specify the
ACL name, the ACL number
is used as the default ACL
name.
Optional N/A String (upto 20
characters)
Command
Modes
Global configuration mode
Table 4-15: Pre-Configured QoS Classification Rules and Class-Maps
IP Interface Type of Traffic Protocol Source
Port
Class
Map
DSCP 802.1p
Bearer RADIUS UDP 1812 1 7 7