User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 259 System Manual
 “Restoring the Default Configuration Parameters for the PMIP Client
Functionality” on page 260
 “Displaying Configuration Information for the PMIP Client Functionality” on
page 261
4.3.10.4.1 Configuring Parameters for the PMIP Client Functionality
Run the following command to configure the PMIP client functionality to specify
how registration of a MIP-incapable MS should be managed:
npu(config)# mip-client [mslifetime <timeout>] [mslifetime-guard
<percent>] [registration-retries <retransmissions>]
[registration-interval <timeout>]
NOTE
You can display configuration information for the PMIP client functionality. For details, refer to
Section 4.3.10.4.3.
IMPORTANT
An error may occur if you provide an invalid for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config)# mip-client [mslifetime <timeout>] [mslifetime-guard
<percent>] [registration-retries <retransmissions>]
[registration-interval <timeout>]
Privilege
Level
15
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[mslifetime
<timeout>]
Denotes the maximum
period, in seconds, for which
the HA will maintain the MIP
binding. This information is
sent in the MIP registration
message. At the end of this
period, the NPU de-registers
the MS.
Optional 9000 0-9000