User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 262 System Manual
For the current release, specify bearer as the value of the ip-intf parameter.
However, the IP address should already be configured for the bearer interface. For
details, refer to “Configuring Static Routes” on page 211.
NOTE
You can display configuration information for ASN interface. For details, refer to
Section 4.3.10.5.2.
IMPORTANT
An error may occur if you provide an invalid value for this parameter. Refer the syntax description
for more information about the appropriate values and format for configuring these parameters.
Command
Syntax
npu(config)# asnif <ip-intf>
Privilege
Level
15
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
asnif
<ip-intf>
Denotes the IP interface that
is to be exposed towards the
BS and other ASN gateways.
Ensure that the IP address
for the bearer interface is
configured before executing
this command.
Note: If you are modifying the
ASN interface, save the
current configuration (refer
Section 4.3.4.1) and reset
the NPU (
Section 4.2.2.1)
for the change to take effect.
Mandatory N/A bearer (only
the bearer
interface is
supported in
the current
release)
Command
Modes
Global configuration mode