User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 268 System Manual
4.3.10.7 Configuring the Data Path Function
The Data Path function controls the creation, maintenance, and deletion of data
paths within the NPU. This section describes the commands to be used for:
 “Configuring Parameters for the Data Path Function” on page 268
 “Restoring the Default Parameters for the Data Path Function” on page 271
 “Displaying Configuration Information for the Data Path Function” on
page 272
4.3.10.7.1 Configuring Parameters for the Data Path Function
To configure the parameters for the data path function, run the following
command:
npu(config)# datapath [initpathregreq-retries <retransmissions>]
[initpathregreq-interval <timeout>] [msderegreq-retries
<retransmissions>] [msderegreq-interval <timeout>]
[pathregreq-retries <retransmissions>] [pathregreq-interval
<timeout>] [pathregrsp-retries <retransmissions>]
Display
Format
Authenticator Function Configuration :
eapidreq-retries = <value>
eapidreq-interval = <value>
ntwentry-holdtime = <value>
eaptransfer-retries = <value>
eaptransfer-interval = <value>
reauth-attempts = <value>
reauthcmplt-holdtime = <value>
eaptransfer-roundtrips = <value>
pmk-lifetime = <value>
pmk-guardtime = <value>
authfailure-holdtime = <value>
max-ntwentry = <value>
Command
Modes
Global command mode