User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 272 System Manual
4.3.10.7.3 Displaying Configuration Information for the Data Path Function
To display configuration information for the Data Path function, run the following
command:
npu# show datapath
4.3.10.8 Configuring the Context Function
The context function manages the contexts of various authenticated MSs. You can
specify parameters pertaining to context creation and reports. This section
describes the commands to be used for:
 “Configuring the Parameters for the Context Function” on page 273
Command
Modes
Global configuration mode
Command
Syntax
npu# show datapath
Privilege
Level
1
Display
Format
Data Path Function Configuration :
initpathregreq-retries = <value>
initpathregreq-interval = <value>
msderegreq-retries = <value>
msderegreq-interval = <value>
pathregreq-retries = <value>
pathregreq-interval = <value>
pathregrsp-retries = <value>
pathregrsp-interval = <value>
pathregstart-interval = <value>
mipwaitdhcp-holdtime <value>
Command
Modes
Global command mode