User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 273 System Manual
 “Restoring the Default Configuration Parameters for the Context Function” on
page 274
 “Displaying Configuration Information for the Context Function” on page 275
4.3.10.8.1 Configuring the Parameters for the Context Function
To configure the parameters for the context function, run the following command:
npu(config)# contextfn [contextreq-retries <retransmissions>]
[contextreq-interval <timeout>] [contextrprt-retries
<retransmissions>] [contextrprt-interval <timeout>]
NOTE
You can display configuration information for the context function. For details, refer to
Section 4.3.10.8.3
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config)# contextfn [contextreq-retries <retransmissions>]
[contextreq-interval <timeout>] [contextrprt-retries <retransmissions>]
[contextrprt-interval <timeout>]
Privilege
Level
15
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[contextreq-re
tries
<retransmissio
ns>]
Denotes the maximum
number of times the NPU will
retransmit a context request.
Optional 3 1-5