User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 274 System Manual
4.3.10.8.2 Restoring the Default Configuration Parameters for the Context
Function
To restore the default configuration for the context function, run the following
command:
npu(config)# no contextfn [contextreq-retries]
[contextreq-interval] [contextrprt-retries] [contextrprt-interval]
[contextreq-in
terval
<timeout>]
Denotes the period, in
milliseconds, for which the
NPU waits for a response to
the context request. If the
NPU does not receive a
response to this request
within the period specified by
this timer, the NPU
retransmits this request.
Optional 10 5 - 100
[contextrprt-r
etries
<retransmissio
ns>]
Denotes the maximum
number of times, the NPU
retransmits the context report.
Optional 3 0-5
[contextrprt-i
nterval
<timeout>]
Denotes the period, in
milliseconds, for which the
NPU waits for the context
report acknowledgement. At
the end of this period, the
NPU retransmits the context
report.
Optional 3 0-5
Command
Modes
Global configuration mode
NOTE
Refer to Section 4.3.10.8.1 for a description and default values of these parameters.
Command
Syntax
npu(config)# no contextfn
[contextreq-retries] [contextreq-interval]
[contextrprt-retries] [contextrprt-interval]
Privilege
Level
15