User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 278 System Manual
4.3.10.9.3 Displaying Configuration Information for the MS State Change
Functionality
To display configuration information for the MS state change functionality, run
the following command:
npu# show msscfn
NOTE
Refer to Section 4.3.10.9.1 for a description and default values of these parameters.
Command
Syntax
npu(config)# no msscfn
[msscrsp-retries] [msscrsp-interval]
[sbc-holdtime] [reg-holdtime] [msscdrctv-retries] [msscdrctv-interval]
Privilege
Level
15
Command
Modes
Global configuration mode
Command
Syntax
npu# show msscfn
Privilege
Level
1
Display
Format
MS State Change Function Configuration :
msscrsp-retries = <value>
msscrsp-interval = <value>
sbc-holdtime = <value>
reg-holdtime = <value>
msscdrctv-retries = <value>
msscdrctv-interval = <value
Command
Modes
Global command mode