User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 286 System Manual
Run the following command to configure the output parameters for this bearer
plane QoS marking rule:
npu(config-bqos)# config [outer-dscp <integer(0-63>] [vlan-priority
<integer(0-7>] [qos enable]
IMPORTANT
Enable the bearer plane QoS marking rule that you are configuring. By default, all bearer plane QoS
marking rules are disabled.
NOTE
You can display configuration information for the bearer plane QoS marking rules. For details, refer
to Section 4.3.10.11.6.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-bqos)# config [outer-dscp <integer(0-63>] [vlan-priority
<integer(0-7>] [qos enable]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[outer-dscp
<integer(0-63>
]
Denotes the Differentiated
Service Code Point (DSCP)
value to be used for marking
the packets, if the packet
complies with the marking
rules specified in
Section 4.3.10.11.1
.
Optional 0
 0-63

[vlan-priority
<integer(0-7>]
Denotes the VLAN priority to
be assigned to the packets if
the packet meets the
requirements of the marking
rules specified in
Section 4.3.10.11.1.
Optional 0
 0-7, where
7 is the
highest
