User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 288 System Manual
4.3.10.11.4 Terminating the QoS Marking Rules Configuration Mode
Run the following command to terminate the marking rules configuration mode:
npu(config-bqos)# exit
4.3.10.11.5 Deleting Bearer Plane QoS Marking Rules
Run the following command to delete the a QoS marking rule:
npu(config)# no bearerqos [<qos-alias>]
Command
Modes
Bearer plane QoS marking rules configuration mode
Command
Syntax
npu(config-bqos)# exit
Privilege
Level
10
Command
Modes
Bearer plane QoS marking rules configuration mode
CAUTION
Specify the QoS alias if you want to delete a specific bearer plane qoS marking rule. Otherwise all
the configured bearer plane QoS marking rules are deleted.
Command
Syntax
npu(config)# no bearerqos [<qos-alias>]
Privilege
Level
10