User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 296 System Manual
4.3.10.12.2.3 Configuring Parameter for QinQ Service Interface
After enabling the QinQ Service Interface configuration mode, run the following
command to configure the QinQ service interface parameters:
This command shall configure one or more parameters of the QinQ Service
Interface.
npu(config-srvcif-QinQ)# config ([descr <string>] [ServiceIfVlanId
<integer(1-4094>])
4.3.10.12.3 Restoring the Default Configuration Parameters for a Service Interface
This section describes the commands for:
 “Restoring the Default Configuration Parameters for an IP-IP Service Interface”
 “Restoring the Default Configuration Parameters for a VLAN Service Interface”
Command
Syntax
npu(config-srvcif-QinQ)# config ([descr <string>] [ServiceIfVlanId
<integer(1-4094>]])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
config [descr
<string>]
A description of the service
interface.
Optional null String (up to 70
characters)
ServiceIfVlanId
<integer(1-409
4>]
A Service Interface VLAN ID
shall not conflict with other
instances of Service Interface
VLAN ID and VLAN IDs of
Bearer, Local-Management
and External-Management
interaces. Shall also not
conflict with CVID of any
transparent MS.
Optional 0 0-9, 11-4094
Command
Modes
QinQ Service Interface configuration mode