User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 297 System Manual
4.3.10.12.3.1 Restoring the Default Configuration Parameters for an IP-IP Service Interface
Run the following command to restore the default configuration for IP-IP service
interface tun-mtu and/or tun-chksm parameters:
npu(config-srvcif-ipip)# no [tun-mtu] [tun-chksm]
You can restore only one parameter to its default values by specifying only that
parameter. To restore both parameters to their default value, run the command
npu(config-srvcif-ipip)# no.
4.3.10.12.3.2 Restoring the Default Configuration Parameters for a VLAN Service Interface
Run the following command to restore the default configuration for a VLAN service
interface tun-mtu parameter:
npu(config-srvcif-vlan)# no [tun-mtu]
NOTE
Refer to Section 4.3.10.12.2.1 for a description and default values of these parameters.
Command
Syntax
npu(
config-srvcif-ipip)# no [tun-mtu] [tun-chksm]
Privilege
Level
10
Command
Modes
IP-IP Service Interface configuration mode
NOTE
Refer to Section 4.3.10.12.2.2 for a description and default values of this parameter.
Command
Syntax
npu(
config-srvcif-vlan)# no [tun-mtu]
Privilege
Level
10
Command
Modes
VLAN Service Interface configuration mode